NewTom GO Wall-Mount


PHYSICAL ROOM REQUIREMENTS 

The NewTom GO requires a minimum physical space of 45.9“ wide, 64.5” deep, and 88.8“ tall. The requirements for width and depth take into account the space needed for the patient to walk around the device and for the operator to use the device.

Warning: 24”clearance on right side of machine is compulsory. Failure to meet this requirement will result in ergonomic and operational issues for clinic staff.


MOUNTING OPTIONS



  1. Free-standing base kit for use with floor column (Floor-mount only)
  2. 16” on-center mounting plate with threaded rod - Can be used on it’s own if wood studs 16” on-center exist. (Wall-mount only)
  3. 16” on-center mounting bracket (Floor-mount only)
  4. Standard mounting bracket, 9.8” on-center mounting holes (Floor-mount only)
  5. 45-degree mounting bracket, 9.5” on-center to 16” on-center mounting options (Floor-mount only)

Note: Cefla recommends Bracket #3


ELECTRICAL REQUIREMENTS 

The NewTom GO requires a dedicated 115V 20A breaker with NEMA L520-compliant receptacle and plug. The NEMA L520 receptacle, plug, and supply cable are provided with each unit. Wiring between the outlet and the electrical panel should be rated for 20A. Surge protection is highly-recommended and not provided as part of the equipment accessories.

Important: Do not place electrical outlet directly behind the column

Important: Be aware of voltage drop! Test the circuit to ensure that there is no greater than a 10% fluctuation in supply voltage while under load. For circuits with irreparable and excessive voltage drop it is recommended to have a 220V circuit installed.

Important: Failure to operate the device on a dedicated circuit can result in failed x-rays, corrupt images, and damage to internal components.















NETWORK & CONNECTIVITY REQUIREMENTS
1. Direct Connection
2. Indirect Connection
  1. Direct connectivity is where both the sensor (or flat panel) AND the core network connection of the machine are connected direct to the PC.
  2. Indirect connectivity is where the core network connection of the machine is connected to the office's network and the sensor (or flat panel) is connected direct to the PC.

Note: Cefla recommends direct connection

Warning: Wireless networks are not supported

Important: Flat panel/sensor connections must be connected with CAT6 cabling running at 1Gb.

Important: Do not place network jacks or exposure switch jack directly behind the column.




EXPOSURE SWITCH OPTIONS 

The exposure switch can be mounted next to the unit or it can be relocated anywhere within a 30-foot cable run. If the exposure switch needs to be relocated all that needs to be done is to have a CAT5 or CAT6 network drop run from where you want the exposure switch to be all the way to where the device is installed. Both ends of the cable run will have an RJ45 jack.


SERVER REQUIREMENTS

The imaging database should be installed on an existing file server. All that is needed is a shared directory with full read/write/execute permissions for all client PCs.